Hi
I have a composite door with an ERA 616 multipoint lock that is suffering from rust at the bottom of the faceplate.
So I don't damage the finish of the door slab while removing the rust, I was thinking of taking out the faceplate to work on it away from the door.
In my case the faceplate is just screwed on, there aren't any rivets. I was hoping this means I won't need to take the handles off / remove the spindle to take the faceplate off.
Is this straightforward or are there lots of gotchas do you think?
Thanks
I have a composite door with an ERA 616 multipoint lock that is suffering from rust at the bottom of the faceplate.
So I don't damage the finish of the door slab while removing the rust, I was thinking of taking out the faceplate to work on it away from the door.
In my case the faceplate is just screwed on, there aren't any rivets. I was hoping this means I won't need to take the handles off / remove the spindle to take the faceplate off.
Is this straightforward or are there lots of gotchas do you think?
Thanks
Attachments
Last edited: