- Joined
- 27 May 2021
- Messages
- 1
- Reaction score
- 0
- Country
Hi,
First off I want to say how helpful this forum has been regarding setting up my Texecom 64w system last year. All the information I got from here made it a doddle!
But I've become a bit stumped when trying to configure a part arm for my shed. I'm wanting to enable a part arm to only include the door contact for the shed. This contact is currently assigned to zone 16 on my panel.
I've found lots of information regarding a 'night mode' where you omit a landing PIR. But I'm a bit lost on creating a separate part arm (2?). I have access through a smartcom to Wintex.
Would the process be:
I hope this makes sense!
Thanks,
First off I want to say how helpful this forum has been regarding setting up my Texecom 64w system last year. All the information I got from here made it a doddle!
But I've become a bit stumped when trying to configure a part arm for my shed. I'm wanting to enable a part arm to only include the door contact for the shed. This contact is currently assigned to zone 16 on my panel.
I've found lots of information regarding a 'night mode' where you omit a landing PIR. But I'm a bit lost on creating a separate part arm (2?). I have access through a smartcom to Wintex.
Would the process be:
- Make zone 9 (front door contact) omittable. At the moment the omittable attribute for this is not ticked? i'm not sure on this one.
- On ALL my other devices apart from the shed. Tick the box for Part 2 Omit. So zone 16 is the only zone without part 2 omit ticked.
- In area programming add Area A to part arm silent.
- Then once I enter my user code. I can choose part arm instead of full and choose part 2?
I hope this makes sense!
Thanks,