Hi All,
Got a nice 40mm Oak worksurface all cut, joined and oiled. Currently it's just resting on the kitchen units and some wall battening.
I need to fix the worksurface to the battening and to the units. I've got stretcher plates and plan to drill oversized holes in the unit front rails to allow for movement.
What are the best screws to use for screwing into the oak? I've heard various reports of Turbogold shearing unless full bore pilot holes are drilled, and obviously oak is a hard wood.
Alternatively I could use Quicksilver, or.... what else? Any recommendations?
Thanks
J
Got a nice 40mm Oak worksurface all cut, joined and oiled. Currently it's just resting on the kitchen units and some wall battening.
I need to fix the worksurface to the battening and to the units. I've got stretcher plates and plan to drill oversized holes in the unit front rails to allow for movement.
What are the best screws to use for screwing into the oak? I've heard various reports of Turbogold shearing unless full bore pilot holes are drilled, and obviously oak is a hard wood.
Alternatively I could use Quicksilver, or.... what else? Any recommendations?
Thanks
J