Good afternoon gentlemen, I Have purchased a new diaphragm for my Torbeck Valve. But I am confused on how to fit it, There are two pieces of hard plastic Now these have to point down so the arm can close the valve.
There is a Hard piece of plastic which is spear shaped and I am assuming this goes into the small hole on the edge of the fitting.
Any advice please, As foolishly I took it apart without realising.
Thanks
Garry
There is a Hard piece of plastic which is spear shaped and I am assuming this goes into the small hole on the edge of the fitting.
Any advice please, As foolishly I took it apart without realising.
Thanks
Garry