Turning Internal Doors around ??

[comfortably_numb]

Hi Folks.

I've had a couple of my internal doors re-hung opening outwards. The guy has put a new doorstops on & suggested i fill where the previous hinges were. I have bought some "Ronseal Multi Purpose Wood Filler" but i dont really know where to start :scratch: . Any advice would be appreciated

I've attached picture

 

[big-all]

not quite a door stop

you should have either installed a door stop of 12x18mm or there abouts
or used a wider bit of wood cut flush

hardboard and normal polyfilla would have done

any way fill in the large holes a layer at a time [around 3mm ] sometimes quicker to glue in wood fill and sand down

 

[comfortably_numb]

tHANKS BIGALL

 

[Bilioustrumpstaine]

You can use isopon p38 car body filler and build it up in layers, this has the advantage of curing (to the point of being sanded) in about 20mins so you can get the job done in a day.

 

[comfortably_numb]

Thanks again