Hi all - hope someone can help, just fitted a pre shaped/sloped shower board 1200x1200 to replace the floor in my shower - I've tiled the floor using a unibond pre mixed tile adhesive and grout. This was about a week ago, I've then grouted the tiles (and apart from leaving the grout slightly too long and it being a pig to get off) this seemed OK, however standing on the floor I'm sure I can feel some flex....
The pre shaped board, is a sort of fiberglass foam board (A genuine shower tray) and the tiles are 50mm x 500mm I'm just concerned that the floor wont be water tight...???
Any advice much welcomed!
The pre shaped board, is a sort of fiberglass foam board (A genuine shower tray) and the tiles are 50mm x 500mm I'm just concerned that the floor wont be water tight...???
Any advice much welcomed!