- Joined
- 24 Apr 2021
- Messages
- 2
- Reaction score
- 0
- Country
Hi there,
I have Veritas 8 Alarm
I hope some one can help here. I was insulating my loft and I cut the cable to one of my alarm sensors, only about 5 cm from the alarm so I re soldered it.
This is when the issues started.
Now when I go to set the alarm all PIR lights show they are active, however, the door switch and the panic switch are not lit up.
I can not set the alarm at all.
Here is a video of what is is doing
https://photos.app.goo.gl/6X5nb7t1WxFydv7a6
I have even gone into the alarm box and put a loop connection to the landing sensor to see if that stops the issues, all it does it turn the light off on the open circuits when I try and set the alarm.
The worrying issue is that I cut one wire from a sensor going to the main box, how can this cause every PIR to show that it is open.
I have now been playing around with it that much I have the tamper light on (which I cant get off as as I can not set the alarm)
Any help on this issue would be really good.
Thanks in Advance
I have Veritas 8 Alarm
I hope some one can help here. I was insulating my loft and I cut the cable to one of my alarm sensors, only about 5 cm from the alarm so I re soldered it.
This is when the issues started.
Now when I go to set the alarm all PIR lights show they are active, however, the door switch and the panic switch are not lit up.
I can not set the alarm at all.
Here is a video of what is is doing
https://photos.app.goo.gl/6X5nb7t1WxFydv7a6
I have even gone into the alarm box and put a loop connection to the landing sensor to see if that stops the issues, all it does it turn the light off on the open circuits when I try and set the alarm.
The worrying issue is that I cut one wire from a sensor going to the main box, how can this cause every PIR to show that it is open.
I have now been playing around with it that much I have the tamper light on (which I cant get off as as I can not set the alarm)
Any help on this issue would be really good.
Thanks in Advance