Good evening helpful people
I have purchased a shallow sink and am having problems sourcing a suitable waste. The bottom of the sink casing is flat and there is less than a cm between the sink casing and the bottom of the actual sink - where the overflow water will gather.
Please excuse my terminology.....
In my (extremely non plumber) mind I think I need a waste that has the overflow 'cut outs' starting only a few mm from the top. The cut outs can not exceed 5mm in depth else they poke out underneath the sink and spill water.
Any suggestions as to a suitable solution would be much appreciated.
I have struggled to explain that very coherently - if anyone wants me to have another go please let me know.
Many thanks
I have purchased a shallow sink and am having problems sourcing a suitable waste. The bottom of the sink casing is flat and there is less than a cm between the sink casing and the bottom of the actual sink - where the overflow water will gather.
Please excuse my terminology.....
In my (extremely non plumber) mind I think I need a waste that has the overflow 'cut outs' starting only a few mm from the top. The cut outs can not exceed 5mm in depth else they poke out underneath the sink and spill water.
Any suggestions as to a suitable solution would be much appreciated.
I have struggled to explain that very coherently - if anyone wants me to have another go please let me know.
Many thanks