Looking at fitting Cembrit Jutland fibre cement tiles on a relatively small roof. Quite a low roof, ridge is at 2.5 metres, so fancy having a go myself at fitting these tiles.
Just need some advice on how to finish off the tiles against a side wall. Both pitches and the ridge are against the wall which is about 300 mm higher.
Cembrit on their website show lead soakers with a cover flashing over the tiles. But I have come across some sites showing a continuous running soaker strip, which seems to have a small gutter running down under the edge of the tiles against the wall. How would this be finished under the ridge?
Just need some advice on how to finish off the tiles against a side wall. Both pitches and the ridge are against the wall which is about 300 mm higher.
Cembrit on their website show lead soakers with a cover flashing over the tiles. But I have come across some sites showing a continuous running soaker strip, which seems to have a small gutter running down under the edge of the tiles against the wall. How would this be finished under the ridge?