Was just wondering what is the correct type of drill bit to use to make a hole for the spindle of new door handles? The doors are solid wood.
Which drill bit for door handle spindle?
- Thread starter dominicstar
- Start date
Sponsored Links
go for 15 to 18mm flat bit no need to make it to tight
you can use a half inch bit but leaves no room for error
and when you fit the handles move the handle up and down and sideways on the spindle and centralise on the movement
in other words if the handle moves say 12mm top to bottom the raise it 6mm
you can use a half inch bit but leaves no room for error
and when you fit the handles move the handle up and down and sideways on the spindle and centralise on the movement
in other words if the handle moves say 12mm top to bottom the raise it 6mm
Thanks. I forgot to say I am using surface mounted locks with knobs to replace old ones that are a different size - will this make a difference?
Sponsored Links
If using knobs make sure you use the correct (longer) latches.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Similar threads
