OK I have seen answers to this kind of message but just to be doubly sure I would like confirmation as to what length and Guage of Screw and Rawl Plugs should be used to secure the brackets for hanging Kitchen Wall Cabinets.
The Wall Cabinets are Full Height 720mm High x 290mm Deep (1 x 500mm, 1x 450, 1 x 1000mm).
The Brackets Supplied are 48mm x 26mm and have 2 x Srew Holes 6mm Diameter.
The walls are Cavity Brick Concrete Render with a Plaster skim.
Assume that the cabinets will be full of crockery and tinned food.
I already have two types of Brown Rawl Plugs one is 30mm long with two protruding flanges (Masonary?) with a closed bottom and the other is 45mm long no flanges with a split from the centre to the end both 7mm wide
I suppose they are fine otherwise Howdens would not supply them with thier Kitchens but to be honest the ones i took out seemed far more beefier 3 x Screw Holes and about double the size the cabinets were slightly taller though.
Many thanks
The Wall Cabinets are Full Height 720mm High x 290mm Deep (1 x 500mm, 1x 450, 1 x 1000mm).
The Brackets Supplied are 48mm x 26mm and have 2 x Srew Holes 6mm Diameter.
The walls are Cavity Brick Concrete Render with a Plaster skim.
Assume that the cabinets will be full of crockery and tinned food.
I already have two types of Brown Rawl Plugs one is 30mm long with two protruding flanges (Masonary?) with a closed bottom and the other is 45mm long no flanges with a split from the centre to the end both 7mm wide
I suppose they are fine otherwise Howdens would not supply them with thier Kitchens but to be honest the ones i took out seemed far more beefier 3 x Screw Holes and about double the size the cabinets were slightly taller though.
Many thanks