Hi Folks,
Was wondering if someone could possibly assist with a query I have?
I had to replace my old Scantronic 9200 control panel due to being faulty.
I have replaced it with an Accenta mini (8SP400A-UK). I am keeping the existing sensors, four magnetic door switches and one PIR, and exterior sounder which is a Pyronix Deltabell (replaced for old bell box about five years ago by a local installer). There is also an old bell box at the rear of my house but this has never worked in the 20 odd years I have been here.
My query is, when rewiring the Deltabell back up, do I wire it exactly as it was before or is there any variations in the wiring given that I am removing the old bell box wiring from the rear of the house? Also, if someone could advise me which wires go where at the control panel would be very appreciative.
I have uploaded a photo of the Deltabell as it was wired before.
Thanks in advance
Jim
Was wondering if someone could possibly assist with a query I have?
I had to replace my old Scantronic 9200 control panel due to being faulty.
I have replaced it with an Accenta mini (8SP400A-UK). I am keeping the existing sensors, four magnetic door switches and one PIR, and exterior sounder which is a Pyronix Deltabell (replaced for old bell box about five years ago by a local installer). There is also an old bell box at the rear of my house but this has never worked in the 20 odd years I have been here.
My query is, when rewiring the Deltabell back up, do I wire it exactly as it was before or is there any variations in the wiring given that I am removing the old bell box wiring from the rear of the house? Also, if someone could advise me which wires go where at the control panel would be very appreciative.
I have uploaded a photo of the Deltabell as it was wired before.
Thanks in advance
Jim