I'm looking to save some dosh on new heating controls by making use of existing set if at all possible. Trouble is I'm unsure if WB made any changes other than sticking their name on the front of this Drayton unit.
The receiver on the old boiler is connected directly to the PCB with a small connector using only 3 tiny wires (red white blue). If I were to make a mountable box to fit this, could it be re-used wired to the new boilers 24v output? If so what colour wires are which?
If not would the digistat work with a standard Drayton wireless scr?
Cheers.
P.S: New boiler will most likely be an Intergas.
The receiver on the old boiler is connected directly to the PCB with a small connector using only 3 tiny wires (red white blue). If I were to make a mountable box to fit this, could it be re-used wired to the new boilers 24v output? If so what colour wires are which?
If not would the digistat work with a standard Drayton wireless scr?
Cheers.
P.S: New boiler will most likely be an Intergas.