worktop jig
- Thread starter bigdiy
- Start date
Sponsored Links
I have just done a kitchen and utility where the worktop joint was out of square by 10mm(U shaped kitchen)
I had a successful joint on both counts, after cutting both joints (male & female) 5mm off the original Jig.
It is possible to do almost anything regarding this subject but be sure to sit down and think through what it will mean to other things if the joint is cut out of square.
Andy
I had a successful joint on both counts, after cutting both joints (male & female) 5mm off the original Jig.
It is possible to do almost anything regarding this subject but be sure to sit down and think through what it will mean to other things if the joint is cut out of square.
Andy
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Sponsored Links
