Just finished my mason's mitres on my white laminate worktops. Very difficult . but now perfect with a lot of reading on this forum. I am now about to make the openings for sink etc with my router. Could not bear to use any type of saw incase I ruin it after it took ages to do the joints. What is best silicone or adhesive for the joints and opening cut edges?.
Also when moving and test fitting them about 50 times I have a small chip out of the surface at the back. I have the chip and it fits perfectly. What glue to put it back? PVA, no more nails or something else?
Thankyou
Also when moving and test fitting them about 50 times I have a small chip out of the surface at the back. I have the chip and it fits perfectly. What glue to put it back? PVA, no more nails or something else?
Thankyou