advice needed on non square door frame please.

Marth39

Property is circa 1890s so nothing seems to be square or flat.

I want to replace the living room door but the door fits into the frame at the bottom but seems out at the top.

The current door is wood with 15 glass panels

The previous owners seem to have bent the door at the top so it will fit. This has left a door with a cracked side panel. It turns inwards. There is also no catch and they have been using a bathroom sliding bolt to shut the door from the inside

My problem is that the walls are not flat or true, so any door will have this problem I think.

Any advice on what needs to be done to remedy this?

Many thanks

big-all · Posted: Thu Oct 08, 2009 8:21 am Post Subject:

internal or external door!!!
how much out off line are you talking!!
check and see if the door stop will come off !!

__________________
big all
we are------------------ all still learning

gregers · Posted: Thu Oct 08, 2009 2:04 pm Post Subject:

think the bolt was put there to persuede the door to take the shape of the door frame over time?
as big all has suggested see if the stops will come off?
or you might be able to minimize the ammount by say bringing the butts out or in accordinaly?

__________________
reality is for people with no imagination

Marth39 · Posted: Thu Oct 08, 2009 3:37 pm Post Subject:

It's the living room door (As I said

)
The door fits at the bottom and at the top corner on the side where the hinges are. The other top corner is out by just over a 1cm.

Sorry to sound so ignorant but what are stops and butts? Are they the internal lengths of wood that the door shuts against?

They have all been heavily painted but I will probably heat gun the paint off anyway, so can see if I could angle the one side and the top to take into account the difference. Am I on the right track?

Many thanks

Burnerman · Posted: Thu Oct 08, 2009 4:26 pm Post Subject:

I think you are going to have to fake this one, but 1cm out of true isn't too much...remove the strips of wood that the door closes on to, punch the nails out and lightly tack them back into place so that they follow the edge of the door. See how they look. If they aren't offensive to the eye, then job done...if they are, you could try repositioning the hinges to see if you can compensate for things that way. Not the easiest job if you haven't done it before though! Cheers John

Marth39 · Posted: Thu Oct 08, 2009 4:43 pm Post Subject:

Thanks for that John. I'll have a go as I can't get someone in to do it for me. I'll let you all know how I get on.

I'm also putting up new architrave around the windows for the first time. One down (not too bad) 2 to go

Burnerman · Posted: Thu Oct 08, 2009 4:55 pm Post Subject:

Hey go for it.....a great way to boost your skills and confidence. You'll do no harm. Don't overdo the nail size, and don't fully punch them in until your happy. Cheers John