Several times it has been mentioned in this forum that taps can be for high and low pressure systems . Non of my catalogues indentify the difference .How can they be identified ?
Jim58
Jim58
Taps ,bath and basin
- Thread starter Jim58
- Start date
Sponsored Links
Jim,
Somewhere there should be a guide or table showing what the minimum operating pressures are.
ie Low Pressure 0.1 - 1.0 bar
Mid Pressure 1.0 - 2.0 bar
High Pressure 2.0 & above
These are only rough guesses but shouldnt be too far out.
There may also be a table of symbols. L,M,H
Hope this helps
Rico
Somewhere there should be a guide or table showing what the minimum operating pressures are.
ie Low Pressure 0.1 - 1.0 bar
Mid Pressure 1.0 - 2.0 bar
High Pressure 2.0 & above
These are only rough guesses but shouldnt be too far out.
There may also be a table of symbols. L,M,H
Hope this helps
Rico
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Sponsored Links
