My shower door has fallen off.
It has come out of its hinged part, where it is a tight push fit with a plastic sleeve into the hinge bit.
To stop this happening again can I drill small holes of 6mm with a diamond core dril,l about 10mm from the edge of the glass.
Or will it pop into tiny bits of glass.
thanks
It has come out of its hinged part, where it is a tight push fit with a plastic sleeve into the hinge bit.
To stop this happening again can I drill small holes of 6mm with a diamond core dril,l about 10mm from the edge of the glass.
Or will it pop into tiny bits of glass.
thanks
like when I was carrying one carefully to the skip . BANG and the dirt( and the whole sodding door ) was gone 
