Indesit W161

Joined
26 Jan 2006
Messages
1
Reaction score
0
Location
Manchester
Country
United Kingdom
When starting to spin machine would trip the electric supply. I changed motor brushes as a matter of course, motor then tried to fire up but didn\\\'t and power light went out. Machine now appears completely dead but there is power on the machine side of the filter. Any ideas.
 
Sponsored Links
its probably blown the module in l/h corner at rear of appliance looking from rear. check for burnt tracks, also remove motor plug connector and if u have multimeter check across top 2 pins should be 2-4 ohms if motor goes open circuit then machine can appear dead because the module is fed via the motor circiut.hope this helps rgds gary
 

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Sponsored Links
Back
Top