A 'Square & Crutch' type combination key for turning stop cocks on & off. The handle includes a chisel end for lifting access covers and the overall longer length of the key enables even deeper set stop cocks to be turned on or off.

Made in the UK!   An extremely useful & multipurpose four way key for opening utility meter cupboard doors (gas, water & electricity), allowing access to air conditioning units and mains consoles. This versatile little key will even undo...

The Monument 3034T is designed to clean the inside of fittings and outside pipe surfaces of 15mm and 22mm copper pipes after they have been cut in preparation for soldering or brazing. The Monument 3034T features two carbon steel brushes to clean the...

DIY / Proffesional Adjustable Plumbing Wrench. Helps you get to those hard to reach places. This great  basin wrench has a telescopic handle and spring loaded head. To fit Hex.    

This kit is especially designed for removing stiff backnuts from awkward placed taps. Stays in position on the tap tail so can be used with one hand and uses mechanical advantage of the thread of the tap tail to remove stiff nuts.

For tracing the direction of flow or to where a drain pipe runs. The recommended dilution rate is approx 230g to 9 litres of water. The liquid is then use at a rate of 140ml-250ml per 450 litres, depending on the ground conditions. Approx. 230g of drain...

For tracing the direction of flow or to where a drain pipe runs. The recommended dilution rate is approx. 230g to 9 litres of water. The liquid is then use at a rate of 140ml-250ml per 450 litres, depending on the ground conditions. Approx. 230g of drain...

For cleaning/clearing small drains, inside work and roofs. Do not use for root cutting. Light weight with long reach. Clear lines from rooftop to basement including kitchen, bath and laundry drains. The drum can be removed quickly for more portability...

For tracing the direction of flow or to where a drain pipe runs. The recommended dilution rate is approx. 230g to 9 litres of water. The liquid is then use at a rate of 140ml-250ml per 450 litres, depending on the ground conditions. Approx. 230g of drain...

For tracing the direction of flow or to where a drain pipe runs. The recommended dilution rate is approx. 230g to 9 litres of water. The liquid is then use at a rate of 140ml-250ml per 450 litres, depending on the ground conditions. Approx. 230g of drain...