A pack of 50 1.5mm aluminium bits, manufactured specifically for use with the Power-Tec Miracle System, used for pulling and pushing out dents in bodywork and for automotive welding.

A replacement small rubber pad for the Power-Tec Miracle system, specifically the Double Short Foot tool. Manufactured to protect both automotive bodywork and the tools itself from unnecessary and expensive damage.

Sharpened on two edges, this steel alloy splitter is manufactured to allow for impact to drive body panels apart without damaging them, allowing for an easier to complete and less expensive bodywork repair. Releases body panels quickly, easily and importantly,...

Easy to use, the Power-Tec PullRite is a clever piece of kit, designed to be used with squiggly wire to rough out panel damage. The PullRite simply hooks onto the squiggly wire after it has been welded to a panel, allowing for a firm, gentle pull to remove...

A comprehensive kit ideal for the professional automotive bodyshop, the master hammer dolly set from Power-Tec comes complete with a wide range of hammers, dollies and spoons manufactured for use on various panels around a vehicle and for various bodywork...

For use with the Power-Tec Gluematic Glue Gun, these glue pads are ideal for a wide range of applications and for being used with the Power-Tec glue puller system. In a pack of six these are great value for money.

This 3 point electrode holder is a spare part for the Power-Tec Panel Medic panel repair kit which is used with spot welders or Power-Tec's Tec-Spot system for the easy removal of body panel dents and damage.

Used to gently knock down small bumps in bodywork without damaging the panel and paintwork.

To be used on the inside of bodywork panels, rather than the outside to avoid potential further damage to your precious paintwork. Extended and angled for greater access and featuring magnetic rollers to ensure the tools are positioned correctly when...

Designed to make the job of damage estimators easier, the panel and image profiler from Power-Tec is used to provide a template of an undamaged bodywork panel that can then be compared to a damaged similar panel, to show the extent of the damage caused.