hi all, I've read around this forum a bit about this. Looking like a job for a hinge cutter instead of a forstner bit maybe? This is to do with some mods / additions to an existing kitchen so it has to have doors to match those already in place from some years ago. We managed (finally) to find the same doors but they are not cheap! Three of the doors will need the circular recesses to be cut for hinges. My questions are, what are the chances of getting the holes in without messing up, if I just use a cordless drill hand-held? Can a plunge router, which I could borrow, drive a hinge cutter or forstner bit? (Drill press would be best but expensive for a single job!) Any advice please? Thanks in advance.
Regards,
Terry
Regards,
Terry