Recent content by a13dove

Cheers sparky I figured this earlier so I gave dumped the PA switches from the panel, looped over and looped the tamper too. Funny how they can just go like that. Thanks again for the hints

I did think that but twice in a day ? Didn’t know if it could be dodgy soulder on pcb? Thanks sparky

hi all Yesterday the alarm triggered twice on sos in unset . Both panics are not pushed in & keypads have no sticky buttons. Anyone have any ideas ? Thanks folks !

Hi, I had the valve changed which did seem to improve the problem a bit. But it has returned again this year but nowhere near as bad. I have spoken to an engineer, who seems to think that it's an air mixture adjustment that needs to be done, but I rent and the guy is a bit slow out of the...

I think this engineer is spinning you a line. Most doors will have some form of adjustment. If its still under warranty then contact BSH & tell them to sort it out or replace the machine !!!

hi...clean the draw and the roof of the dispenser compartment.also check the hose that goes to the drum.If all this fails, then look for a hose from the dispenser to the drum ( normally at the top and about half inch in diameter ), this will be a breather pipe that could get blocked.some models...

i have a main combi eco boiler & on heating it makes a droning/humming noise, however, this stops when you put the hot taps on, therefore cutting the heating phase. this then resumes when the heating kicks back in......any ideas ?? i have taken the air out of the rads & the fan sounds ok ...

youre on the right track !!! i cant remember exactly without seeing it but i think as well as the screws at the rear, you have to clips at the front, then give it a good slap backwards and with some luck.......off !!

sounds like the heater tube has gone down ( located right hand side of machine at the base ) or module relay fault( in the top of the door).....

it will either be a broken spring or the plastic/string tensioner from the spring to the hinge arm.easy job !!! no adjustment.....

sounds like a communication error on the module to me.However, if you have a spare lock, sometimes this works. secondly, also found that if you unplug the machine & rub all 3 pins of the plug on the machine casing, it seems to discharge & can reset the module.If this all fails, it seems like a...

Hi all, my father has a smart fit system that seems to have a re-occuring fault.It would seem that about every 2 years he has to change the acctuator.He has done this several times now, and changed the cable also, with the most recent being 3 weeks ago & today it comes back up with the F2 fault...

Change the capacitor. It will be that. Unplug the machine & leave it an hour so the capacitor dis-charges.remove it & change it, located on the side of the motor....... Happy drying !!!

Online at espares I would say.

sounds like you've got a wta2000 which was made by white knight/philips. Door frame is reasonable price & would also agree with previous reply that your capacitor requires changing !! unplug !!!! If you have this model, there is a fella on here looking for some help with wiring the mains...