if i remember a y plan can take up to 60000 so i would use this it would prob be good if some one could show a drawing for this design im sure some of the big boys can do it
my friend is plastering a wall which has blown behind a radiator I SAID I WILL TAKE IT OFF BUT IT WOULD HAVE TO BE OFF FOR A COUPLE OF DAYS TILL PLASTER DRYS..... :? CAN I PUT 2 PLASTIC PUSH FITS ON THE END OF PIPE. or can I just close lock shield and valve as the person still wants to use...
can you help i have a boiler and cold water storage system in the attic
the thing is when i turn hot water out there is no force at all it takes ages to fill the cold water is really powerfull compared i had some one out who blew the pipes back it was ok for a couple of days but back to normal...
Can any one help i have a brown staircase and dado rail etc going from hall way to upstairs I want to paint it all white had quotes for £110 per day would rather try myself but dont no where to start
any help please
It is from combi......not sure if its 8ml but very small holes on bottom off tap fitting how do i go about fixing it to bottom off tap does it just screw in
I have just been asked to fit a mixer tap on neighbours bath he has 22ml pipe comeing into old taps but these new ones don't have no pipe on the end its just flat it has really small holes on the bottom like 8ml not sure? can i get a reducer from 22 to that and what do i connect it to?
do i...
well thats what i basically did apart from shut down service valves...
If that doesn't work what do you think the problem is, its everytime heating comes on it looses pressure and goes to under 1 bar and if i top it up white dial goes other 3 bar comes out of prv and im back to normal
I have put air in expansion vessel to 1 bar. I have changed pressure relief valve to a new one but every time i put heating on water comes out of prv and once cold boiler shows under 1 bar please help dont no what else to try
I have found the valve on expansion vessel what do i need to do to put air back in and how will this stop water comeing out of prv
what exactly does the expansion valve do?
how do i fix it?
thanks for the help