Recent content by Drogna

Fresh batteries in, same problem.

Thanks for your reply. The programmer in the airing cupboard is in the "on" position and set to manuel. Not sure if the gas fitter ran a test as i was at work when he did the job. I'm pretty certain that its not been working since the gas pipework was done. The electrics were done a day or so...

I've recently had a new kitchen and extension completed on my house and since the works been completed I've lost all my heating and hot water. It's a Y plan system that i used to switch off and on (for heating) using the thermostat in the lounge, only because the programmer is buried at the...

Just a quick thank you to all who posted on here - changed the synchro motor last Friday and everythings back to normal! Thanks again! :D

Thanks for the extra info guys - the motor's dead easy to get too, not at home at the moment so I don't for sure if it's a removable one but I'm 99% certain it is.

Softus - thanks for your input. 1. The boiler does switch on and off under the control of the programmer - tried this last night with the new batteries in and it was working fine. 2. The pump also switches on and off under the control of the programmer. 3. No, the MZV is not reacting...

Pride comes before a fall! I had a "luke warm" night as the rads never fully came on, although the thermostat triggered the boiler and the pump was working well - still it was better than nothing. So now I have a couple of questions: 1) Let's assume that the programmer is battery powered...

Thanks for that bab - I'll check that tomorrow, but at the moment I'm glad I've got some heat for tonight!

New batteries and the display is back to life - right, gonna have another tinker now, reckon I've got this sussed now. Thank you so much for all your help guys, very much appreciated!

Can't find any switches but I've just discovered a battery panel with a couple of AA's in it (use by July 1997 - might replace those and see what happens)!

First thing I checked Corgiman! The airing cupboard was a little full, but not that it pressed any of the buttons. My main concern is the blank screen on the programmer - can't seem to get any life into that at all!

Nope - you're quite right, it doesn't! According to the literature it comes from a "sundial wiring centre"! Doesn't help me much sadly! THe pump was working when I checked earlier, but its not now! The immersions off, we tend not to use it. The boiler is stil working.

Hi - I'm a newbie here so please be gentle! I've got a Honeywell Sundial "Y" plan system installed in my house (probably about 20 years old now) and this evening the heating's gone off! The thermostat in the lounge still clicks but it doesn't fire up the boiler. I can still get hot water...