Recent content by finalspin

hi folks, the tumble works but then stalls with the motor still humming, if i open door and spin the drum then restart it will then work for another while.. is it the belt? motor? if its the belt is it easy replaced or should throw in in the skip? cheers

as title, must be 3 door and very clean with service history.. paul

update: i decided to take all the stone cladding off completely, i bought a sheet of fire/cement board and cut it to size and fitted with wallplugs to the wall, i covered a bigger area also to protect the skimmed finished wall even more, i must say its a tidier and much cleaner looking job, im...

ive had a horrible time with stone cladding behind multi stove, they were bonded to the scratched skimmed wall finish, however, after 3 weeks they went boast and came away from wall, i decided to remove all the stone and have just installed fire/cement board, much tidier and will protect the...

the heat this evening seams to be gradually lifting it, its like residue sellotape leaves behind if that makes sense, anyway, seams to be clearing slowly but surely!

cheers, i used a scour sponge with fairy liquid and it took of all the black and brown stains, although the glass has a metalic/frost effect now? like a film on the glass? not sure how to shift this though?

im burning chipboard, mdf and mostly coal... it has the airwash system, it says on the booklet not to use anything "abrasive" so surely it wouldnt be wise to use a scour pad etc??

have been using the stove now for over 2 months, it was brand new and usually when cleaning it out i just dampen some kitchen roll and the discoloured glass comes up like new, this morning i cleaned out the fire and went to wipe glass clean only to find it will not shift! ive tried everything...

you have been full off knowledge, so, in short, these 2 products used with my stone veneer will sheild the heat from my skim and also create a bond for my stone work to the wall behind my wood burning stove? sorry for all the questions but hopefully this is the end of my problems lol

skim on wall behind the stone work hasnt went boast at all, can you list the name of primer and bonding i need to do the job again as the wall is fine and if i get the stone to stick to the wall it will then protect the skim if fixed with the correct product this time.. thanks again folks

the bonding has come clean off the wall and stuck firm to the stone veneer, the skimmed wall is clean, you would swear nothing has been on it!

how much will this cost? some say the weber because its just a mortar base cement couldnt stick to the wall? i can email pics so you have better idea if you forward email? paul

the walls were skimmed/finished 6 months previous and allowed to dry naturally, didnt prime wall, the shop i bought the stone veneer off seamed to think the weber would do the job but now i know different.. is there a heat protection primer/bonder out there that will stick these to the dam...

nope, skim/plaster is perfect..

built a new extension, fitted a new stove, where it sits in the corner i have put stone cladding/veneer pieces to wall with webber bonding, they have now went boast and coming away from wall, the skimmed wall was well scored before fitting but they came away, i have been told to use expanding...