Recent content by finkployd

Oh, i also forgot to mention, i think i pressed the start and cancel buttons a little too hard (partly out of frustration) and now the buttons are stuck in and don't click.....ooops. Have i broke the springs or plastic clips at the back of the buttons? If so, are they easy to fix/replace? :?

I have been given a Hotpoint washer-dryer by the in-laws (model WD640). It was working for them, it's been in their shed for a couple of months before being transported to my house. I've connected the machine in my house but when I turn the power on at the socket the lights on the front of the...

I removed the tube and connector from the pressure switch and gave it a couple of thumps against the concrete block. When I reset the machine and tried it again the original problem didn't reoccur (see above) but now the powder tray rinses with water and the drum starts to turn, but the machine...

i will try that, thanks very much sleepyhead! :wink:

I counted the flashes - 8 flashes! Same as everyone else it seems. Sleepyhead, you mentioned an error chart, can this be found online or is it an engineer's "bible" thingy? Does it sound like something an amatuer could fix or solve or is it a bit too complex? Basically, is it worth just...

have just read other posts regarding "spinning dials" with other Indesit machines. I haven't counted the number of flashes to indicate what the fault is, but going off expert "sleepyhead" the number of flashes doesn't always indicate the correct fault. I take it that guessing a wiring fault...

Hi, the belt came off my Indesit WI121. I've put it back on again, but now when I select a cycle it washes the powder into the drum and starts to turn the drum but then stops - the light flashes and then the programme dial starts to spin round on its own and won't stop - the washer also...