Recent content by jezmoz

The shut off valve is in the pipe that is located outside the property (usually attached to a horrendous white box). You can have the meter in an out house if you have one (we have). But they have to be able to isolate the gas from outside of the property.

anyone know where i can buy this valve to stop the condensation on my toilet?

:o

it was in B&Q for most of its life by the look of it, then transported from there to my house. :D Just too impatient. :lol:

I want to get cracking with laying some laminate but the box says to leave for 48 hours to acclimatise? Is this necessary? :lol:

B&Q has a fairly decent range... prices are much the same £22-£30 a pack 0f 2.22m squared (for decent laminate.....cheaper stuff is available (that horrible nasty yellow laminate).

I have built a pond and i'm currently holding the liner down with rocks i found around the garden which show all the liner in it's glory, It's 10ft by 5ft, I want some material that will overhang the pond and hide the liner edges. I have toyed with slate, stone and railway sleepers all seem very...

there might be a problem with the valve/flow switch, that operates the flow of water usually held next to the hot water cylinder tank, there shoud be a box that has a flow switch that can stop the flow of hot water into the heating or taps. Uually 3 settings, one for the radiators and one for...

hi lee I'm a web designer if you get stuck let me know. My email has been removed ____________________________ Lynda, moderator please read the forum rules

probably window motor, but check the rubber grommet near the door hinges for broken wires and also check the fuse related to the electric windows and the actual switch itself.

it's a chrysallis a buttefly or moth

Hi, I have an area that i wish to deck, I don't want a raised deck as this will allow neighbours to see us. I wish to have a ground level deck. At the moment the ground is just soil/clay. What would be the best approach to lay a deck on this? I don't want to buy a crappy kit. I want a deck that...

please advise :D I need a strong drill and really strong bits, the last bits melted and mangled and the drill broke (walls are reaaly hard)

can you recommend a beast for under a ton? and some decent masonary drill bits to go with it?

a combination of silicone and no more nails, and tape it with strong adhesive tape for a day to harden without getting it wet. worked on a big mirror I put up 8)