Hi everyone, hope u are all having a nice evening :) Im a gas engineer+have been called to a rental property with a (lovely) Heatline Vizo boiler sat in the corner of the kitchen! Flue pipe is horizontal and is too short...doesnt project through the external wall at all. Ive looked everywhere...
Hey guys!
Thanx for the advice...i will be looking at the boiler again tomorrow...will let u know if its pcb, flow switch or...whatever! :o)
Cheers and hope the sun keeps shining for all of u!
Jim...
Hi guys!
Hope someone out there can help me with this!
When i turn off the room stat, the heating goes off, when i trun the room stat up, the heating will not start back up at all. If i run the hot tap, the boiler heats the water and when i turn the tap off the heating starts back...
Chrishutt?? Where have u gone :?:
Does anybody else think that increasing the speed of the pump will get the rad hot? I just dunno what to do next...i dont want to admit defeat and get her to call another plumber (unless its one of u guys!!)
:wink:
Thanx for your reply Chrishutt! :)
I was also thinking that it might be something to do with sludge buildup, i really dont like primatic systems!!
I think u might be on the right lines with the rad being on the suction side of the pump...when i bleed the rad until it is full (with the...
Hello to all of u again!
Hmmm, ive still got problems with this primatic, one pipe system...any of u SuperPlumbers got any ideas? :D
I drained the system and refilled it. Everything is going well except for the rad in the bathroom. When the heating is on, the pipes to the bathroom rad...
Tomy, Scatmanjohn and Coppercylinderman! U guys are stars...drained and flushed system a few times and now fingers crossed its sorted. Whenever u guys are in Cardiff...the drinks are on me, serious! :D
Hiya everyone, my apprentice made a bit of a mistake last week...added Sentinel sludge remover to a Primatic system while i was on hols. Got back from sunny Spain with a verrry unhappy lady on my phone. Basically, the hot water is now contaminated and air bubble in cylinder is gone...is there...