Hi all
I need to bead some corners (internal & external) but the problem being the angle is something like 30 degrees & the normal 45 degree metal beading doesn't seem flexible enough to bend.
I've seen the metal jointing tape & this would solve my problem, but i've read that it's not that...
Hello all
Woke up this to find no water at all is coming out of any hot water taps cold tap is fine, hot was fine last night??? .
Also i tried to top up with the filling loop & there's nothing happening, no water flow.
It's a crappy Saunier duval f24e combi before anyone asks & i know how...
Hi all,
I've got a saunier duval f24e boiler. I know they're a pile of ****e, but i'm stuck with it for now.
Basically when i turn hot water on the boiler fires up ok but then turns off after 20 seconds or so, then re-lights again 20 sec.. off again...so on & so on. So the water never reaches...
I've tested the expansion vessel & no water comes out at all, re-pressurised it & although i've taken water out of the system, i'm not sure how much ie.possible false pressure reading......got it working again last nite/today (lowered temp settings) & checked pressure return valve & it was...
It only drips when i fill but no matter what i do it stays at 1 bar. I've let some air out of expansion vessel & dosent appear to be any water coming out.
I got it running again today for a few hours but alas its back to flashing fault. Could it be a combination of expansion tank needing...
Don't know but it fired up & ran for at least an hour until it reached temp despite it staying at 1 bar...??. Its back to flashing red now, the filler does put water but it'll slow & stop after 10 secs or so as though its full but bar gauge still doesnt move from 1 bar.
Could it be the water...
Hi Kev,
Thanks for your reply, looking at the manual its the 'reduced pressure zone valve' where it appears to be dripping, which sits next to the 'prv'.
When i drain some water off it stops dripping. Could the prv still be part of the problem.
Hi all,
New on here & have a problem so pls be nice :) .
Seems these boilers have got a bad reputation for being unreliable but unfortunalely for me im stuck with it, for now at least.
Right boiler light is flashing & led display for water is showing just under 1 bar, in the past when this...