Recent content by PK Gas

No overide button?

Is the reciever built into the boiler or do you gave an external one?

A in 1 B in 3

Not what you want on a Saturday evening :cry:

Beat me to it

Usually you can tap the the lockshield when on the tail piece to slide the olive further into the tail piece it can be tight though

This is what it looked like after first couple of cuts and was mowed at highest setting

Can anybody steer me in the right direction I laid turf in may and it has been beautiful until noticeably the last 2 cuts. The ground is heavy clay but was forked and rotavated then left for a year after moving in then 3 ton of topsoil was put down raked and walked in before turf laid. The...

I have almost completed my sleepers project although my wall isnt as tall as yours. I did however change my plan a little and went for 16mm rebar through the bottom sleeper set in concrete and then 300mm timberlock screws on the second row I did take the advice and put some 20mm gravel behind...

Makita 10.8v suitable for most jobs and if you look about you can get the drill and impact driver within your budget I have them aswell as an 18v Bosch drill and impact driver and often find that I don't use the 18v unless I have a lot of work to do and battery life is important

Yes I've used these before with no issues Insert in the 15mm plastic pipe push your fitting home and the other end into the bottom of the trv with nut and olive connection

If it makes you feel any better about it they are a b******d to get apart without the tool they have a locking ring type fit I've yet to see someone pull one out

What your suggesting will work Any reason behind not wanting to use the push fit method as it will certainly look a lot better than what your suggesting?

Looking at the swivel fitting your thinking of using looks like it uses a washer sealing method but the trv will be a compression type with an olive You may be better of with something like this...

http://www.plumbingproducts.ie/chro...chrome-327-compression-swivel-elbow-15mm.html Are you using these to go from the plastic to the trv?