Recent content by wookster

Hi guys, not been on here for a long time as had no troubles lol, I have a Bosch wae24162gb that seems to be boiing the load, could it be the thermostat or the heating element?, any linters would be fantastic please

hi Chris, the boiler is a 100e, does this have a diaphragm action?. Cheers

Morning, I've checked the boiler and it's a 100e not a 100E. I also tried the tap on upstairs at a trickle and the hot water is very very hot!, but with the tap full open it's cold, hope this helps. Many thanks

Hi Chris, I'll double check tonight if it's a 100E or 100e, many thanks

Hi Corgiman, well the pressure was about 2bar, then dropped back down to just over the 1, which i think it is how it should be set. with the taps on upstairs about half a turn the water still is pretty cold, any ideas?. Many thanks

Afternoon all, I wonder if anyone can help, I have a wonderful Protherm 100E combi boiler, (not another junk one out there). The problems I have is that the pressure drops over a day or 2 to just over the 1 bar. Heating wise no problems at all, it’s the water heating that is. I turn...

Morning all, just wondering what would be suitable to join the panels, is it a putty type of resin, and any recommendations? Cheers

Hi i wonder if anyone can help, i have a garage at the end of my garden i'll need to run power to, the overall run length will be 130 foot, i plan to use a 3 phase converter to power a 2hp lathe and do the lights etc, what kind of cable size should i be looking to use bearing in mind the voltage...

yeah played about with the machine lastnight, pressure wasn't great, so connected the cold from another source, and seemed to work fine i it was down to the water pressure :lol: the drum bearing might be shot now though!!! are these easy to change, and where would i buy them from :wink:

yeah it sticks several times though the cycle, and does the first rinse and that's it. :cry:

Yes mate the drum is turning and the bushes seem to be fine, not sure wether it's just the timer? :cry:

Morming i have a hotpoint WD62, when put on a washing cycle ie: E, it will not complete the cycle, i have to move on the settings to spin and drain and rinse on the dial. :evil: any ideas what it could be, cheers :wink: Steve