Recent content by yiano1234

Hi all, I am currently setting up on my own as a plumbing and heating engineer. I am just wondering, when you re-fit a bathroom for example. Where would you dispose of the old one? All the local tips near me, specify commercial, trade or industrial waste is not permitted. And with my van...

Hi all. I have recently purchased the sky wireless adapter so that I can watch on demand sky tv. But I can't seem to get it to connect with my router. I have BT home hub and all my other things connect to it fine, kindle, ipad, etc so I know it is not a password problem. When you go to the...

I think all the air is out, as when it is on hot water only it circulates fine. :(

Hi, I have a honeywell 3 port vavle that is causing me so many problems! It has already been changed once and still problems persist. Both the heating and hot water are on, on the programmer and both stats are calling for heat. The pipe going into the bottom of the 3 port is red hot, as is...

Can you fit a red pressure vessel to a normal vented cylinder? This way I can do away with the F and E tank and just have the cold water storage tank. Obviously would be fitting a temp and pressure relief on the red pressure vessel.

Maybe try turning the new stop cock down a bit, see if that makes it the same as it was before?

Yes, It must be a wiring fault somewhere, as I have now just changed the body section of 3 port and the fault persists. It use to work fine, but the boiler was changed in the garage last summer. There is also a frost stat in the garage. I think the problem has only come about since then. What...

Yes, you can buy an adapter that fits on the black pipe and converts to copper. This is usually a type of push fit fitting, so you have to make sure there is enough black plastic sticking up from the ground. Also that it is free from any major scratches, as this will make it leak. You can get...

At my mothers house we have recently found that the heating is not always working and sometimes she doesnt have any hot water. If I push the mid position valve manually it will open and remain open. (rads get hot etc). However if I then turn the room stat down I hear the mid position valve...

thanks for your help. Think I will go with getting rid of the f and e and putting a pressure vessel in, and stick it up in the loft. The boiler isnt too old, maybe 3 years. Will buy replacement flue parts. Sorry for the typo, yes I meant combi not comi. :oops:

Hi, Does anyone know if you can put a normal condensing boiler in the loft. This is on an open vented system. Would, I just have to make sure that the f and e tank is higher than the boiler? All the pump, zone valves, etc will remain in the airing cupboard bellow. Just want to move boiler...