Scantronic 9450

Joined
16 Apr 2024
Messages
4
Reaction score
0
Country
United Kingdom
Hi my elderly aunt (she’s 82) has a scantronic 9450. Never had any problems with it till last night. The arm started sounding even though the alarm was in a disarmed state. She used her user code and the alarm stopped. It went off a total of 5 times through the night and twice again today. I have searched and found the installation and users guide but there is no fault finding listed on it. She says all of the lights are illuminated
 
Sponsored Links
Battery faulty ? , it’s an old panel from late 1980s , there are no fuses , poly switches.. so a short on ….eg bellbox due to water can make it go off …
 
Thanks SparkyMarka. I’ll have a look and hopefully be able to repair it but I have prepared her for the fact she might need a new system.
 
It was just the fact that it sounded when it was disarmed. It was windy last night so I’ll check the bell box and the wire going there in case it is loose and flapping about causing an intermittent fault. Thanks again
 
Sponsored Links
Thanks. Tamper warning light not lit just Zone1, zone2, zone3 and PA
 

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Back
Top