Search results

Hi all, My wash basin single lever mixer tap is leaking from nozzle. Could you please advise whether I need to completely replace the cartridge or just a rubber ring/washer etc and how would I do that? Many thanks.

Hi every one, Could someone, please, shed a light on how an engine overheating system on Nissan Micra (Tekna) 2008 work? My car ,during a recent summer day, stopped suddenly without any prior warning but started again after a cool-down . This car, unlike my previous Micra, does not have...

hi all, Could you please advise: My vaillant828 has started to produce on and off some alarming noises during operation. The noise is as if bricks or stones are raining down on the inside of the boiler. Is it a trapped air or what? I would have thought that a trapped air would produce a...

Calling all Computers Know-how-ers , Please help! I don't know what it is, may be it's the prevailing heat, my Toshiba Laptop A100 has gone mental. One moment it says: 0MB free ( i.e. no free space) Another moment it says: low on disc space Then another: 209MB free from 37.1MB And...

Hi all, Horn of my nissan micra 2008 has stopped working. Any ideas/tips,please.......please.

hi all, reference vaillant 828,there is a small drip from an area between the inlet water connection of the appliance and the large nut associated with the cold water service valve. I have tried tightening the nut a bit but to no avail.I am not sure whether the source of the drip is from...

Hi all, Could I have your suggestions as to what's causing the dampness, please? A year ago, I had the outer side wall in the alleyway of my house rendered , but during the course of the past 4 months or so we have been noticing dampness rising fron the base on the inside of that wall...

Hi all, Could you help with this little baffler,please. The brush bar on my Dyson 04 has stopped turning when in a "auto brush on" mode. I have checked that the belt is not broken, there is no obstruction in the roller housing and the motor runs normally. Perhaps there is a faulty clutch...

Hi all, I am somewhat at loss as to how to remove the existing pressure guage from my ecomax 828 boiler.The boiler manual states that the guage is factory-fitted . Also I can not see anything I could unscrew or pull at the capillary end. Would you also please advise how to drain the...

Hi all, There appears to be a resident sludge in the pipework of my vaillant boiler 828, possibly causing erratic movements of the needle on the pressure gauge. I wondered if I could clear the boiler without having to do the full system flush. Also, I suspect that even if I did the full flush...