Search results

the round hold is in the wheel arch liner which is held between the bracket and the rectangular hole which is why i am saying i need to attach it to something fitted to the rectangular hole

its a box section, no access behind the hole.

it's the bracket i am holding that needs bolting to the rectangular hole,

there is not an "edge" to slip a chimney nut over, it will have to be some sort of cage nut that inserts from the front as it is a box section with no access from the back.

Hi, I am trying to get my fiat scudo 2006 ready for it MOT after a long lay off and found that the bracket for the ABS cable has no captive nut to screw in to. I have had a search around but am unable to find the correct type of fitting. If anyone can point me in the right direction it would be...

so just put some lengths of wood across or do you mean a full apex roof type structiure? what depth would you suggest for a 5.2m span and at what spacing to support a suspended ceiling? would the 13m metal frame wall need beefing up to support the load or should a standard 70mm C section be ok...

Hi, looking to build a room within a barn, 5.2m x 13m. 1 wall will be current block side of barn. 3.6m heigh, with suspended ceiling at about 3.2m. I need to brace the 13m wall that is opposite the 13m block wall and provide support for the suspended ceiling. the walls are easy, it is the...

i was going to go with a floated Finnish which i understand is smooth? i will probably use a padded trolly thing most of the time but it must not keep getting stuck on ridges well if its got to be 100mm that's what it will have to be.

would you build some sort of retaining structure around the perimeter for the timber garage to be supported on, a sort of strip foundation and then insulate between that and the floating fllor. 100mm seems a bit thick to heat up, would it not be better to lay 50mm or 75mm with a reinforcing...

all heating will be underfloor as it will be running of an oil boiler running on home made biodiesel, can't afford to pay for fuel for a garage. i think that if some area's are not heated then i could get cracking between the hot and cold sections. i also may park more on one side or the...

i'm not keen on pumping heat in to the ground as its just a waste, what about putting a steel mesh in the screed how much will that improve its strength? I will not be fitting any lifts as i don't want to make it to high, hence the warm floor as most of it will be done laying down...

no not fixing to the floor, the banjo will be in the cider shed. :D this is already built as you have to get your priorities right

I am in the early stages of planning my garage/workshop, I have allocated an 4mx9m area for it, the workshop will have a lathe and milling machine and the garage section will be for working on my land rover and transit. the garage will be timber. I will be installing wet...

I think its a common fault with this model. I had the main board replaced twice for this fault.