Search results

Seems like i just have a towel warmer. About as much use as a chocolate fireguard at this time of year. Any suggestions on what output i should look for to heat a small room if i replace the rail. I could replace it altogether and look for a stylish replacement. I have it wired to a timer...

I have had an electric radiator installed in a new shower room and it is not heating the room enough even when it's left on all the time. I can't see a make, but it looks like a central heating towel rail but runs on electric as it was too difficult to tap in to the rest of the system due to...

I have a White Knight drier ( CL787) which was working fine until the belt snapped. I replaced the belt and now the drier runs for approx 1 min and then cuts out. The fuse is ok and if i press the start button again it does the same cycle and cuts out again. I didn't touch any electrics whilst...

I may be reading it wrong but it sounds like opening up the cold flow more solved your issue. I would have thought i need to turn the cold to a more restrictive position to balance the flow and hopefully get a hotter shower. I may try turning the mains cold off just to eliminate the mains feed...

The hot and cold were tapped off a seperate cloakroom sink/toilet feed so i assume it is not mains fed but not sure how i woud check with the pipes not visible now. Would turning off the mains tap tell me as i assume it will still feed from the tank if it was tank fed until it emptied. Should...

I have a new power shower with a pump in the garage and a two dial on/off and temp in the shower. The pipes run a fair distance around the house/garage to get to the shower room extension. The problem i have is the water is not quite hot enough. I have pressed the anti scald button to turn the...