Search results

  1. Grover2000

    Alarm recommendations

    Can someone advise on a good alarm that can be used in my garage which is located opposite my house (It has power)? Some thieving bar-steward broke into it and made off with my stuff. Any help is greatly appreciated Grover
  2. Grover2000

    Hoover OPH714DS Fault help

    Hi can any one advise on the possible fault on my Hoover washing machine OPH714DS - 80. It is about 3 years old and has developed a fault. When the machine programme is set it comes on and seems to go through the motions of the programme but without the motor running to turn the drum. I...
  3. Grover2000

    Shower door roller replacement.

    Hi does anyone has any experience of replacing shower rollers? I have attached the present one but it is broken and I need to source replacements. Any help on this issue is greatly appreciated. Grover
  4. Grover2000

    Stoves G550 problem

    Hi I have the Stoves g550 with a few issues. 1 When the glass lid is closed one of the hob buttons don't self close 2 The fan stays on all the time Has anyone else had the same problems and how to cure them? Any help on the matter is greatly appreciated Grover
  5. Grover2000

    Veritas r8

    Hi can anyone advise how to diagnose the fault on my alarm. After testing the panic scenario by pressing 3 and 9 together I noticed that the alarm external Bell only sounds for about 3 seconds whilst internal sounder sounds until the panel is reset. Any help on the matter is greatly...
  6. Grover2000

    Biasi M90 32s fault

    Hi could some advise the fault with my boiler. It has started to make a buzz sound just as it should fire up but doesn't. The electronic diagnostic lights show no errors. Could the relays be not latching? Hence may point to the ignition board? (wanted to attach a video of the fault)...
  7. Grover2000

    Biasi M90 32S fault guide

    Hi could someone please advise what could be causing the problem when in DHW mode and the green outside service LED's flash alternately and the middle is solid red. Yet when in CH mode there is no problems? Fault code: Lack of burner ignition (no ignition signal from the full sequence...
  8. Grover2000

    M90 32S Boiler primary circuit power flush

    Hi can some one advise how to power flush the boiler's primary circuit. I need to do this before ~I replace the gland which is leaking. Thank you Grover
  9. Grover2000

    Biasi M90E 32s with Honeywell cm921

    The boiler is five years old and is leaking at the gland and the main green light pulses in 2 second intervals. The boiler state is that whilst DHW is intermitant and there is no CH. After removing the clock plug from the pcb the ch sarts to work fine but when it is pluged back in ch stops...
  10. Grover2000

    Cistern siphon 1 push button fault

    Hi can anyone advise what could be the matter with my 1 push button siphon? It was working fine for five years but suddenly what started as a intermittent fault and now stopped work full stop. The fault is when the push button is pressed nothing happens. I have taken the lid off and...
  11. Grover2000

    Biasi M9E.32 leaking at flow switch

    Hi I have had this boiler for four years and had it power flushed in November 2010 and the engineer also pumped some air in the boiler as it was low. Unfortunately the boiler has developed a fault and is leaking 1-drop-per-20-second. Could someone advise what the fault could be? flow...
Back
Top