Search results

thanks for your reply Woody. I`m just waiting on some plans to contact building reg`s. I would of thought I`d need the lintel with the joists being above, its not an arch as such but just an opening with curved corners. I`ve read all kinds about padstones and colums because of thermalite not...

I was just going to have an open archway, no door, would 4 ft not be acceptable ?

Hi sorry again the wall is load bearing, it wasnt on the garage side as the joists ran the same way but on inspecting underneath boards upstairs the bedroom joists run in to it. Would you think I`d need a structual engineer to calculate the load or would building reg`s tell me this. The only...

Sorry it is 140mm thanx for replys.

Hi I want to open up the wall in to my integral garage can anyone advise on what lintel to use. the wall is single 150 mm thermalite block with about 4 course of brick above and is not load bearing the width of the opening will be approx 4 ft. cheers in advance. peter.

Hi can anyone help i am converting my integral garage and wondered if i could use an insulation board which i could lay down and then lay the floorboard straight on top without using joists. It would be the chipboard tongue and groove type, I am hoping this will bring the floor up level with the...

Even if the garage is being converted to a reception room whith a through room in to the lounge :?:

thanks alot guys great help :lol:

Thanks a lot for a quick response Kevplumb :) If i come from above down to the rad should i take 22mm as close to the rad as poss or can i use 15mm straight to flow and return.. :?

hi i want to add a radiator in my garage to my existing system, can i run from another radiator or should i tee in to the in feed and out flow 22mm and could you tell me where the flows are best located..cheers. :?: