Search results

Good Evening, I think i need to refill and bleed one of my UFH loops. I have a connection point on the lower manifold for to bleed but nowhere on the upper to connect mains water. There is a small bleed valve on the top manifold above the temperature gauge, is this where i am supposed to use...

Good Morning, I replaced all my old unipor mechanical thermostats with the Honeywell DT90E's a few months ago. All was going well until the one in the room that uses the most heat started constantly clicking on off like a clock. I read on here that if a reset doesn't fix it then the thermostat...

Good Morning, Ive just been out to the plumber's to get a new Digital Thermostat for my UFH. Currently i have 4 x Unipipe Analogue units and have just picket up a Honeywell DT90E to try before i buy another 3. The Unipipe has 3 wires - brown/live, black/neutral and grey/ arrow. Any idea if this...

Hi, I have the drips from the pressure relief valve on the megaflo which tells me i need to recharge the air gap. When i close the water supply to the megaflo, open the lowest HW tap i get only around 5 seconds of water flow before it stops ( manual tells me it should take up to 20mins )...

Hi all, I have a question about my DHW, i have read through all the Megaflow instructions and cannot get an answer that i'm happy with? Right i have the 210i Megaflow tank with a Danfoss CP715-si programmer. I see in the megaflow instructions they mention the Danfoss TP9000? is this the...

Hi everyone, hope there's someone on here that can take a look at my pic's and see if there is anything wrong? Basically i moved into a newbuild house 18months ago that was fitted with oil central heating, UFH downstairs - Radiators with TRV's up - Megaflow tank for the hot water. I...