Search results

The battery was fitted on initial installation coming up 5 years ago now, ah well. Thanks for the reply

Hi, I have recently had a problem with this panel during power cuts. had a power cut the other night which set the alarm sounding(external bell also), so I have changed the panel battery. after simulating a mains failure again I have had again the alarm going off. so checked the battery...

cheers, will have a look at its rating tomorrow, basically if it run it for a minute or two and it doesn't take the bell fuse out it should be fine?, but what would the connections be? ta

thanks for the reply, but with trying to keep the cost down i was looking at using these, plus I think another bellbox on the garage is a little over the top for what I need. is there a way of using these items in scb mode? or would the siren alone or a similar type without the strobe be...

cant smile wide enuf

hi, I have an alarm system fitted (accenta panel/ pyronix deltabell), and have added an extra zone for the garage. the zone side is up and running but want to connect an extra siren and strobe on the garage itself. I have 2cores available for each, but am unsure of connections from the...

Yes it was on e/e zone, didn't realise there was a pre alarm. switched it to zone 1 to test, problem solved thanks for your help :)

thanks for the reply. I have now done this but still have a problem. the siren works fine when in best test mode, but when I simulate an actually alarm situation it doesn't ?? the panels internal speaker sounds but no siren. does this suggest a faulty panel or am I missing something? what...

Hi, could you help me with this queory. Im trying to connect a siren to my scantronic 9450 panel. it is a separate siren (not a bellbox) with just red+ and black- wires to connect. how do i connect this and close the bell tamper circuit? i am also going to connect a separate strobe in the...