Search results

Pull cable the handle was attached to hard,bonnet should open.

Tickly tee do you write novels for a living.First thing to check is water valve opening to allow water to flow into heater...

your problem sounds as though you are losing a small amount of pressure in cooling system giving rise to coolant loss.I have often found the rad cap to be the culprit,which may not have been tested.Pressure testing may not show a loss if the problem is minute,but for starters try a new cap,if...

Look around the back you will see black mesh grille, is this covered in dust & fluff If so clean it off.I assume youve tried turning up the temp setting.

sounds as though youve left off a positive cable try looking behind battery remember some pos cables on fords are black.

Are you sure youve connected and turned on water supply

Overheat cut off device is behind pump,perhaps you might look it up.

Looking at boiler you will see pump(silver round part) Behind pump is black plastic button.press in.Also check you have enough water in boiler itself,as well as heating section.Try bleeding the boiler using bleed nipples located at various points. (Brass coloured) Regards J

Noseall would you care to elaborate?

Sounds like fuel pump relay, But you say they checked the fuel system.As its getting on a bit, wouldnt do any harm to change it, not expensive.

So what happened when they looked at it? Did they manage to start it? Or did they give up?

When recovery mechanics have checked it, did they say there was a spark or not? I assume there wasnt if they told you to renew distributor.

Thanks for all your input guys.Daz you have got it spot on,I wanted to see what other working guys think of the situation.Generally you think they are well above the weight limit that will do me.Ill simply refuse to handle them on my own.Thanks again J.

Cheers crafty ,not in union,Never anyone there to give me hand etc.I thought I would ask you guys on this site,Knowing I would get some honest opinions, J.

Cheers john Im in england now.

Initial reactions please.Do you think lifting a machine 2 feet sq 3 feet high weighing 50kg, off the ground and into a van,on your own, is an acceptable task to be asked by your employer? well on friday I was told to pick up 8 all at the same site,after the fifth one I hurt my back and refused...

Try unlockme.co

I think the point Johnny is refering to is have you loosened the water pump bolts /and physically moved the pump? I would recommend renewing the pump now anyway,they are prone to leaking.This will also aid you in fitting the belt,as turning pump in its housing increases/decreases the belt...

Baby sitting . Waiting for the Khan fight. One round! Lucky punch or what.Anyway how did you establish timing marks? Regards J.

Try this-put old & new belts on each thumb stretch arms out, keep thumbs straight, stretch as hard as you can, any difference will be immediately obvious.(one belt will be slacker) Once youve confirmed belt is ok,Look again at set up, problem is definitely staring you in the face!I reckon...