Search results

  1. L

    Cable size

    On the copper tank in the airing cupboard is a Satchwell dial that goes from 40 to 90 (i have it set on 40 ) the cable that goes from it to the wiring box is a grey flat type 10mmx 5mm it has been there since the house was built but in order to tidy it away i need a longer cable could you tell...
  2. L

    Cistern drip

    When i flush the cistern it fills up and then it drips very slowly if the cistern is not flushed it would come out the overflow (this would take days )i have fitted a new diaphragm but still drips . thanks for any ideas
  3. L

    Hot water problem

    I have a Glow.worm 24hxi and a Danfloss programer CP71SI In the winter i had no problems but now i only need hot water i find i can only get hot water with the heating on and the thermostat turned up to turn the heating on . Tried temporary override buttons but cannot get just hot water or any...
  4. L

    Heating controls

    In the kitchen there is a boiler above it in the airing cupboard next to the hot water tank is a metal box on the wall 4 1/4"x 5 1/4" marked Stachwell Sunvac there is a relay+ 5 amp fuse and a board. Below it on the pipe is a small metal box marked Douval says domestic water with arrow pointing...
  5. L

    omron my4 relay help no heating

    I am trying to find a replacement for a Omron my4. item 14 pin. 5 amp 240vac. 5 amp28vdc. coil 220/240 . can you please look at item 330365926214 on Ebay, Omron MY4IN 24vdc 4 pole relay and tell me if it will replace it . Or any other that will. thankyou
  6. L

    Omron my4

    I am trying to find if you can buy this relay anywhere local to portsmouth or near or anywhere ? Omron my4 contact 5amp240vac. 5 amp28vdc. coil 220/240vac there is a number 2646w2 on it. my fitter thinks you can no longer buy it? or is there a replacment .?
  7. L

    boiler +programer problem

    Have problem with boiler or programer ? had Siemans rwb2e fitted but small metal bit inside fell off. fitted new Danfoss cp715 si straight swop . but boiler is acting the same as when old rwb2e was fitted .When it is switch on a small noise comes from inside , but it does not fire up ? do you...
  8. L

    electric spur

    I want to know if i can run two fused spurs from my cooker socket( this has a socket for a 3pin plug on the front but i do not want to plug the cooker electrics into it)?one is for a hood 5 amp. and one for gas cooker electrics 3 amp . the back off the socket has a 2 lives (one marked mains) 2 N...
  9. L

    Siemans RWB2E

    Hi i have been removing some tiles from my kitchen wall some were tight around the rwb2e programer the programer moved abit, now it will not work ,when i switch it on no lights come on but i do hear a small sound in the boiler? . I have checked the wires that connect to the pins and all are...
  10. L

    extractor

    I am fitting a new kitchen and new extractor hood but the new oven will be moved about 6"so i will have to fit the new hood about 6" away from old one . will i have to drill a new hole through the wall or is there a way around it? longer trunking etc ?
  11. L

    POWER WASHER PROBLEM

    I have a McCuclloch power mac 1300 washer . when i turn it on pull the trigger the water comes out the lance and it will fan but there is no pressure. The pressure gauge is showing zero and doe not change if i turn the pressure adjuster ? could it be the brushs? on the moter thanks for any ideas ?
  12. L

    power washer

    Hi can anyone tell me what the operating pressure should be on a McCULLOCH power mac 1300 power washer, the dial goes up to 160 bar and just over 2000 psi ? thanks for any help .
  13. L

    cistern siphon leak

    Hi Iam trying to fit a new siphon but after fitting every thing back together i have a leak under the cistern it looks like it is coming from where the siphon is fitted thro the cistern, the rubber ring in on the inside as required and is tight . i had this problem with the old siphon and had to...
  14. L

    glow.worm 24 hxi problem

    Hi today i drained my radiators to fit a new valve in heated towel rail in up stairs bathroom have turned water back on blead rads heating is working ok but hot water tank does not heat up no error nos. coming up on boiler but lot of water gurgling noises ? last time i tried it shut down :cry...
  15. L

    Room thermostat

    hi does any one know what the conntact breaker gap should be set to on a wall room thermostat mine is on the lounge wall and when i was wallpapering i unscrewed the wrong screw and the gap moved . the thermostat is a scatchwell . thankyou for any help .
Back
Top