Search results

I've been knocking through into the extension today, with a fair bit of hammering and banging. The bathroom is very close to where I've knocked through. Gone to have a shower tonight to get cleaned off...a couple of minutes in, the temperature dropped right down to barely lukewarm. Its an...

Hello, I''ve had a quick search for tha answer on this but nothing came up. Installing the above...22mm to a first floor extension. Got plenty of chipboard screws 5 x 50mm.....do I also need to glue the joints? If so, is this to prevent future 'squeaking' ? Many thanks Lee

Hello all, I'm having a pro come to fit an EDPM roof over the front of the garage but I'm gonna fit the cladding myself. The cladding across the front of the garage needs replacing......it spans the garage and porch. The cladding needs to be 450mm deep. The span is five metres. I'm...

Hello, don't bite my head off.....I know no-one can give an accurate evaluation without seeing the job....just need to know if I'm being ripped off or not. Flat Roof......I've put all of the timbers, insulation boards (celotex with ply on top) in. Approx size is 2.3m x 6m....think its...

Hello, I have an old Potterton Puma 100 that is located in the loft and the flue goes straight out through the gable end wall. I am in the process of building an extension onto the side of the house so the old flue outlet will be covered by the new building. I cannot extend the horizontal...

Evening everybody, After some useful advice on this site, have finally managed to change the wax capsule on the Potty. Aboslutely gutted to find a slow drip leak on the union of the DV / wax capsule housing. The actual housing has a rubber seal and from what I can see just pushes onto...

I know this is the last things the experts will want on a Friday night but I'm stuck. Problem - Boiler firing for thirty seconds on CH and then cuts out. Thought I'd have a go at changing the wax capsule myself and now wish I hadn't ! Does the nut in front of the two DHW pipes undo? If...

Good evening all, I'll try to be concise as possible: From the brilliant advice on this forum, I think the PCB on the Potty has gone (no mains lights on boiler, fuse in mains suppy ok, when I press the 2amp fuse on the PCB (with an insulated screwdriver!), the mains lights briefly flash...

If anyone has any advice about the above I would really appreciate it. I am a complete novice but have replaced the water pressure switch as recommended in the fault finder in the instructions but the Low Pressure Light remains on. Thanks very much. :cry: