I made the mistake of not checking that the ceiling joists were level before screwing on my plaster boards. It wasn’t until I screwed it all on and stood back to notice that a joist in the centre was probably 20mm shorter than the others.
My original plan was to use easifill on the screw holes and paint it. No skimming as I don’t possess the skill.
I am now wondering if I can “iron this out” by using a straight edge and smothering easifill into this section and smoothing it out with the large straight edge.
I could remove the board but it’s now all screwed on and I am concerned that it’s probably permanently moulded as it’s been there for 7 days.
Thanks in advance.
My original plan was to use easifill on the screw holes and paint it. No skimming as I don’t possess the skill.
I am now wondering if I can “iron this out” by using a straight edge and smothering easifill into this section and smoothing it out with the large straight edge.
I could remove the board but it’s now all screwed on and I am concerned that it’s probably permanently moulded as it’s been there for 7 days.
Thanks in advance.