I have an air source heat pump and as a result (I think) the water in all the taps, particularly bathroom taps) is at low pressure.( It takes ages to fill a bath!!). How do I get over this problem? Is it possible to install a pump and where should this be sited?
Did you have an open vented hot water system before? You inc mains pressure may be low causing a low flow to the taps. This is presuming you did not have an unvented cylinder previous to your ashp installation.
It does if he previously had an open vented hot water system and moved to an unvented system with bad mains pressure. You'd like to hope the installer checked this before the change over if this is the case.
If you need to find a tradesperson to get your job done, please try our local search below,
or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Please select a service and enter a location to continue...
Are you a trade or supplier? You can create your listing free at DIYnot Local