It's only a year old and it's started playing up.
When the central heating is on, if you switch a hot water tap on, it's failing to cut over to the hot water - it tries about 3 or 4 times then registers a fault "LO" which according to the manual is "ignition" After resetting the central heating eventually kicks back in but the hot water problem is still there.
Any ideas - is this owt to do with the diverter?
When the central heating is on, if you switch a hot water tap on, it's failing to cut over to the hot water - it tries about 3 or 4 times then registers a fault "LO" which according to the manual is "ignition" After resetting the central heating eventually kicks back in but the hot water problem is still there.
Any ideas - is this owt to do with the diverter?