Hi all. I have/am about to complete the install of my new kitchen. Looks amazing and can’t believe I’ve done it tbh…however I have an issue with a couple of my wall cabinets. The wall the 800mm is on looks like it isn’t and has a bulge about half way down the cabinet. As a result it isn’t quite pulled against the wall at the top (on those hanging brackets) although is against the wall at the bottom. Should it be the opposite? Should it be pulled in tight at the top and shimmed at the bottom? For clarity, I’m a paranoid diy’er and have it screwed through the back and onto studs as well as the brackets. Horror stories abound about these cabinets though and I don’t really want it falling off or being generally “not done properly” as I’ve been so careful elsewhere. I know about scribing etc but really rather not get it off the wall *again*.