Bosch Exxcel WFO2064GB Front Load Washer
On a wash cycle the MC gets to the spin cycle, the pump drains, the drum rotates back and forth a few times at a slow speed for about a minute, then the MC stops and the timer sets itself to 0:00 (no error codes).
I have replaced the brushes, cleaned out the drain pipes thoroughly.
After some reading, this could be related to the speed/loading control on the motor (this manages load balancing in the drum before spin up), would that seem a good place to look, I am being told to take the motor to someone who can test the load/speed sensor by putting the motor on a bench and measuring the resistance ... would I be correct in this diagnosis - or are their any other avenues to look up.
Could I measure the resistances with a meter myself with the motor still in the machine ? and can anyone direct me with what values and contacts to measure from on the motor.
On a wash cycle the MC gets to the spin cycle, the pump drains, the drum rotates back and forth a few times at a slow speed for about a minute, then the MC stops and the timer sets itself to 0:00 (no error codes).
I have replaced the brushes, cleaned out the drain pipes thoroughly.
After some reading, this could be related to the speed/loading control on the motor (this manages load balancing in the drum before spin up), would that seem a good place to look, I am being told to take the motor to someone who can test the load/speed sensor by putting the motor on a bench and measuring the resistance ... would I be correct in this diagnosis - or are their any other avenues to look up.
Could I measure the resistances with a meter myself with the motor still in the machine ? and can anyone direct me with what values and contacts to measure from on the motor.