Buying Advice Required for Very Simple Alarm Unit

[Brownstone1892]

Right, I've got it on the wall, and got power into it, now need to connect the sounder and contacts.

Here's where the wires from the sounder went on my old alarm:

https://dl.dropboxusercontent.com/u/403006/Old Alarm.JPG

and the yellow and blue wires:

https://dl.dropboxusercontent.com/u/403006/Old Alarm 2.JPG


And here's the terminals on the new one:

https://dl.dropboxusercontent.com/u/403006/Veritas8.JPG


Just not sure what wires to insert where? I can manage the zones, and the battery connection.

Any help would be greatly appreciated.


Cheers,

BS...

 

[sparkymarka]

Right put the red from old panel with the white from old panel into A on new panel, the black from old panel into B on new panel and green form old panel into S on new panel, now remove the blue and yellow from the connector block these two will be the other cores on the bell cable, ok put one in D in new panel the other in C, the other pair of blue and yellow are your panic alarm wire into any zone and program as panic...

 

[Brownstone1892]

Thanks for all of your help guys, especially Sparymarka. I wired it up as you suggested, but there is a dedicated set of terminals for Tamper, so I put the two blue wires off the contacts in those, and connected the two yellow ones together, and it seems to be working fine.

All programmed, tested and working spot on. I can relax a bit now.

Thanks again guys,

BS...

 

[sparkymarka]

I take there wasn't a panic button ?

 

[Brownstone1892]

No, there is no panic button mate.

Cheers,

BS...